Note: The list of supported
USB dongles gets constantly updated with additional front-ends that can connect
to the Perytons™ Bluetooth Smart Protocol Analyzers for capturing data. It is
strongly recommended to check the Perytons™ site for an updated list of
supported front-ends, drivers and firmware.
Due to limitation on the
front-end side (FW, etc.), not all front-ends can run with all the Perytons™
Bluetooth Smart Protocol Analyzers' models. See http://www.perytons.com/SupportedHardware/
for details (being this dependent on the specific dongle/s used for capture,
special attention is advised if dongles not provided along with the Perytons™
Bluetooth Smart Protocol Analyzer product are used).
•Texas Instruments CC2540 Bluetooth Low Energy USB Dongle
Supported models: Peryton-Smart,
Peryton-Smart3
Required firmware: http://www.perytons.com/files/sniffer_fw_cc2540_usb.zip
Known
limitation: if the Bluetooth Smart session connection parameters change
requests (e.g. hopping time slots, etc.) takes place using encrypted messages,
the new parameters will not be considered and the new time slots will not be
followed by the receiving dongle.
Required Drivers: http://www.perytons.com/files/cebal2.zip
•BlueGiga BLED112 Bluetooth Smart Dongle
Supported models: Peryton-Smart, Peryton-Smart3, Time-sync assisting dongle for Peryton-Smart3
Required firmware:
•for Peryton-Smart
and Peryton-Smart3 capture dongles: http://www.perytons.com/files/sniffer_fw_cc2540_usb.zip
Known
limitation: if the Bluetooth Smart session connection parameters change
requests (e.g. hopping time slots, etc.) takes place using encrypted messages,
the new parameters will not be considered and the new time slots will not be
followed by the receiving dongle.
•for Time-sync: Default FW arrives with the dongle
Required Drivers:
•for Peryton-Smart and Peryton-Smart3 capture dongles: http://www.perytons.com/files/cebal2.zip
•for Time-sync: Windows standard USB drivers
•Nordic Semiconductor nRF51822 EK board – as capture device
Supported models:
Peryton-Smart
Required firmware:
http://www.nordicsemi.com/eng/Products/Bluetooth-Smart-Bluetooth-low-energy/nRF51822-Evaluation-Kit
Required Drivers: http://www.nordicsemi.com/eng/Products/Bluetooth-Smart-Bluetooth-low-energy/nRF51822-Evaluation-Kit
•Nordic Semiconductor nRF51822 USB dongle
Supported models:
Peryton-Smart
Required firmware: http://www.nordicsemi.com/eng/Products/Bluetooth-Smart-Bluetooth-low-energy/nRF51822-Evaluation-Kit
Required Drivers: http://www.nordicsemi.com/eng/Products/Bluetooth-Smart-Bluetooth-low-energy/nRF51822-Evaluation-Kit
•Nordic Semiconductor nRF51822 EK board – as TG device
Supported models: Peryton-Smart3 +
Peryton-Traffic Generator Add-On
Required firmware: http://www.perytons.com/bluetooth/support/supported-hardware
Required Drivers: https://www.segger.com/jlink-software.html